QGL1500-800 Special processing equipment for former axle with functional module is a new designed appropriative shot blast machine.And is suitable for surface cleaning and strengthening in rectangle and special form workpiece such as cylinder workpiece ,small cylinder spring ,bearing etc.
This type shot blast machine have larger capacity,and better sealing effect,and with good cleaning effect ,higher productivity,less
environment pollution ,and maintenance cost reduce sixty percent.
 After surface cleaning and strengthening,that’s not only suitable for surface rust and oxidation skin removal and cleaning casting module-sand ect.but also suitable for the elimination of stress concentration and enhance anti-fatigue of nlthe work piece .the machine can be used not only as a single machine ,but also as a part of a line.

Features
 Direct loading and unloading, need not turning over the workpiece.
 
 Using popular no pit form , Save the foundation pit construction cost.

The shot blast cabin and the arrangement of the shot blast unit are designed by Computer 3d dynamic simulation. Let the abrasive shoted out coverage of workpiece surface covered accurately,and the abrasive from different direction
shot to different surface of  the work piece.

The 130-4RK type large power shot blast unit Using world development technical ,that could raise productivity and get satisfactory clean effect. Using BARDUN ® bearing,Operating factor of shot blast abrasive raise fifteen percent .
Operating factor of wearing parts service raise sixty percent,maintenance reduce fifty precent .

Adopting bag type dust collector, thickness of letting dust lows national standard,and improving work condition.

With novel design the machine can be maintenanced easy and can be used not only as a single machine ,but also as a part of a line.

The workpiece transmission system can turning corotation and reverse.

This machine have the equipment of failure automatic check.adopting advanced +GF+technology,so the product have advanced and reasonable design.operating safety,and high productivity.
                            
 working process

Locking start —loading—workpiece transported into the shot blast cabin—check the workpiece position—transported and remember the workpiece  actual position by the automatic system of the equipment— start the shot blast unit —abrasive cage open—shot the transporting workpiece—workpiece drawed out off the cabin —using unloading roller chain transport—during loading and unloadingd period abrasive can be circulated at the same time.This equipment can be working